How To Repair Swing Pipe

Water Works

By Larry Walton, Photos by Tim Walton

It'southward not of import to know that my brother Chad backed a trailer over our broken sprinkler. The important affair is that we get it fixed. Of course my brother, Chad, the i who bankrupt this sprinkler, was nowhere to be found when it came time to repair this thing, merely I'thou not dwelling on information technology because

I just demand to become it washed—even without my brother's aid.

The fact that the geyser coming from the yard was depositing dirt and rocks on the sidewalk indicated that the pause was downwards deep rather than higher on the pop-up sprinkler. Sure enough, when I pulled on the sprinkler head, it came correct out of the footing. I was disappointed to see that this was not simply a cleaved riser. In that case an extraction tool could accept gripped the remaining riser pipe to back it out. Finishing the fix would only require threading in a new one.

Time to leave the shovel and go downwards to the eye of the matter. A word of caution here: Be careful with the shovel because y'all tin can cause a trouble worse than the one y'all are trying to fix.

The goal when getting through the grass is to fold back the sod then y'all can replace it in ane piece when the sprinkler repair is done. You have to get deep enough to avoid damaging the roots of the grass but not so deep that you get into the pipe that feeds the sprinkler.

Unless yous installed the sprinklers to begin with, you probably will not know the type of pipes that are under the lawn. Fifty-fifty if you accept a skillful guess, you'll still need to dig downwardly to the pipes so y'all tin can run across what parts you'll need.

In our case, the pop-upward sprinkler was fed with flexible pipage. This was not the super flexible pipe like Rainbird Swing Pipe or Toro Funny Pipe. However, the previous homeowner used the same type of fitting that these pipes use. The barbed fitting just pushes into the end of the pipe, going 1 management merely not the other.

Here'due south how I got this repair done without my brother's assist.

When I looked out and saw a geyser at the corner of the lawn, I close the sprinkler zone off and saw that the water had deposited a fair amount of dirt and rocks on the sidewalk. This meant the problem was deep enough below the sod to blast out some substance.

By pulling up the pop-up sprinkler head, nosotros could meet that the elbow fitting that connected the sprinkler head to the flexible pipe was broken at the plow in the elbow.

The initial goal in digging up the pipe is to fold back the sod without damaging the roots of the grass.

Subsequently removing the sod and carefully excavation down to the piping, I plant that the other one-half of the broken elbow was nevertheless in the flexible pipe.

I used pipe cutters to cut the pipe just beyond where the broken fitting extended into the pipage.

A 90-caste barbed elbow simply replaces the broken fitting.

I inserted the spinous fitting into the pipe until you could no longer see the ribs or barbs.

I used the piping cutters to grip the broken connector to unscrew it from the sprinkler head.

The sprinkler trunk threads onto the elbow fitting.

The hole needed some extra dirt before replacing the sod.

I put the sod back in place around the sprinkler head.

I started the sprinkler zone with the sprinkler nozzle removed from the riser to clear debris from the pipe.

After replacing the nozzle, I adjusted the sprinkler and tested it for the running time of the zone.

Source: https://extremehowto.com/poly-pipe-sprinkler-repair/

Posted by: wisemanmuccer.blogspot.com

Share this post